● 光軸校準 Axis
calibration
● 鈕扣鉚合加工 Buttons riveting process
● 基準點定位
Reference point for processing
備 註
Remarks
1.
雷射頭電源連接形式:直接出線紅(+)黑(-)兩條 10cm長電線.
Laser head power connector forms: Direct round red (+) and
(-) two 10 cm.
2. 若使用商用電供應時,請在(+)(-)極間,並聯一電解電容器(建議至少470μf/16V以上).
If you are using to power supply, please (+)(-)pole, the one
parallel electrolytic capacitor
(recommended at least 470 μf/16 V.)
3. 標點直徑會因投射距離﹑角度﹑材料﹑顏色或採光照度而有所改變.
The point diameter of the projection will vary depending on
the projection distance, angle, material, color or
illumination.
4. 特殊規格可依客戶要求訂製.
Special specifications can be requested.